PIPE NIPPLES

Camco Fittings manufactures not only stainless steel nipples in SCH 40, 80, 160 and XXH but also all other exotic alloys. Each nipple, where space is available, is permanently marked with type and heat number for complete traceability.

Plain End Pipe
1. Roller Cut
 
 
 
Minimal Burr O.D.
Burr I.D.
 5. Square Cut - Reamed and Chamfered (R&C)
 
 
 
No Burr O.D.
No Burr I.D.
2. Roller Cut - Reamed and Chamfered (R&C)
 
 
 
No Burr O.D.
No Burr I.D.
 6. Square Cut - Groove-End
 
 
 
 
No Burr I.D.
3. Square Cut - Cut-off Tool
 
 
 
 
No Burr I.D.
 7. Beveled 37.5° - Standard Bevel
 
 
 
No Burr O.D.
Minimal Burr I.D.
4. Square Cut - Deburred
 
 
 
No Burr O.D.
No Burr I.D.
 8. Other - Specify

 

Threaded End Pipe
1. TBE - "Thread Both Ends" (Both ends threaded with standard NPT threads.)   4. NPSL - "Straight Locknut" (Standard straight pipe threads for loose-fitting mechanical joints with lock-nuts.)
2. TOE - "Thread One End" (One end threaded with standard NPT thread. Customer must specify other end, otherwise roller cut will be shipped.)   5. NPSM - "Straight Mechanical" (Standard straight pipe threads for free-fitting mechanical joints for fixtures.)
3. NPT - "Tapered" (Standard tapered pipe threads: National Pipe Taper.)   6. NPTF - "Dryseal" (Standard taper dryseal pipe threads.)
    7. Other - (Specify)

 

Back to Camco's Table of Contents

Back to Capitol Manufacturing's Home Page